#N1mm logger on macos skin#
#N1mm logger on macos windows#

I am getting the odd error/signal-panadapter part in the centre of the screen keeps going white with a red cross corner to corner.the error says :. The new 'black sliders on default 2012 skin' are there now, unfortunately RX2 still isn't doing anything at all.the sliders have zero effect on RX2. VFO changes take forever to do (either click n drag or wheel on Hercules are slooooow.mouse wheel is quck though) but VFO changes on RX1 are instantaneous and fast (normal) I've unplugged the Hercules and power cycled everything.and the 2nd slider (right hand one) still isn't doing anything.the Centre and Zoom are only having an effect on RX1Īlso just noticed that RX2 has gone into 'sledge/limp' mode i.e. changing to some of the other skins causes the odd crash, but not on all of them.

#N1mm logger on macos skin#

The 2 sliders are there (2nd one none functioning) but not on my preferred SKIN i.e. I did a snapshot but Photobucket is having a meltdown on me.gonna have to find an alternative image sharer.

I don't have the 2 'slider' bars like you e to think of it i haven't seen the old slider bar for a while it wasn't a problem as i adjusted the zoom via my Hercules MP3LE midi controller.but this is only adjusting (zooming) on RX1 only.

#N1mm logger on macos windows#

The N1MM screens switch to the appropriate band now (many thanks), although i'm certain i could open 2 'spectrum' windows (was always same band) before.no biggie if that has gone.

So is this a fault, bug or error on PSDR or the N1MM Logger+ Spectrum Monitor ?Īlso FWIW i can open another window (N1MM spectrum) but it always shows the same as window 1.any way i can have 2 windows (spectrum) open but showing the display's from both RX1 AND RX2 ? Several checks/experiments later it didn't matter which way round i altered first RX2 first the RX1 it always defaulted to the 'last' panafall (on PSDR) that i was hovering over (mouse FOCUS) that determined which panafall was displayed on the N1MM spectrum.this wasn't a problem per se but the frequency on the top bar never changed ( always read whatever RX1 was, never RX2 even if the spectrum was showing RX2). I'm not sure if this is a fault/bug but earlier this evening i was listening to 80M (RX1) and 40M (RX2) and had the N1MM Logger+ Spectrum Monitor open on another monitor.this was fine until i came to adjust the vfo on RX1.RX1 adjusted ok.but.the N1MM Logger+ Spectrum Monitor whilst showing the frequency at the top of the window/bar was showing the panafall from RX2 !!.